Bedienungsanleitung NEFF M1463N0

[. . . ] Die Arbeitsplatte muss zur Wand hin gegen Feuchtigkeit abgedichtet werden. Mbel vorbereiten - Bild 1 Alle Ausschnittarbeiten an Mbel und Arbeitsplatte vor dem Einsetzen der Gerte durchfhren. Spne entfernen, die Funktion von elektr. Die Stabi litt der betroffenen Mbel mu auch nach den Ausschnittarbeiten gewhr leistet sein. Einbaumbel mssen bis 100 C tempe raturbestndig sein. [. . . ] Dazu temperaturfesten Kleber verwenden, der fr Metall auf Stein ge eignet ist. Herd einschieben Bild 7 Leitungen beim Einbau nicht einklemmen. Kochfeld ausbauen Das Gert spannungslos machen. Kochstellenstecker und Steuerbox abstecken. Zuletzt den Schutzleiter PE (grn/gelb) von der Erdungsschraube lsen. Kochfeld von unten herausdrcken. en Please note J The cooker is only guaranteed safe in use after proper installation in accordance with these installation instructions. The installer is liable for any losses resulting from incorrect installation. J The cooker may only be connected by a licensed specialist. This specialist must comply with national regulations and the regulations of the local electricity supplier. J Shock protection must be guaranteed by the installation. J The hob and oven must be produced by the same manufacturer and have an identical combination symbol. J They must have the same nominal voltage (see the rating plate). J Observe the cooker installation instructions. J The work surface must be level and horizontal. The stability of the work surface must still be guaranteed after the cut-out has been made. The work surface must be sealed with the wall to protect against damp. Preparing the unit Fig. 1 Cut out the units and the work surface before fitting the hob and cooker. Remove shavings as they can affect the function of electrical components. The stability of the furniture being worked on must also be ensured following the cut outs. The units into which the cooker is fitted must be heat resistant up to 100 C. Minimum distance to the side walls: 150 mm. Seal the cut surfaces to make them heat resistant. This prevents the surfaces from swelling as a result of moisture. Installing the hob Fig. 3 Do not trap the wires during installation. [. . . ] 2 Notes: Use the lower bolt holes on tiled work surfaces. For granite or marble work surfaces: Place pins or bushes for the securing screws or stick on rails. Do this using temperature resistant glue suitable for fixing metal onto stone. Sliding in the cooker Fig. 7 Do not trap the leads during installation. Removing the hob Disconnect the cooker from the power supply. [. . . ]