Bedienungsanleitung AEG-ELECTROLUX ZB2901G

[. . . ] Replace the brush roll and make sure that it fi ts into its guiding tracks, and that it can spin freely. Replace the hatch cover. CLEANING THE WHEELS CLEANING THE BELLOWS 1 If the wheels needs to be cleaned, remove them carefully by using a small screwdriver. 2 Remove objects that have become jammed in the wheel shafts. Reassemble the wheels by pressing them back into their tracks. 1 Occasionally objects can get stuck in the bellows, and this can affect suction power. Clean the bellows after removing the dust cup. 8 Removing the batteries and disposal REMOVING BATTERIES Only remove batteries if product is to be scrapped. 1 Run batteries flat and disconnect UniRapido from the charging station. [. . . ] When housing shows visible signs of damage. On hot or cold cinders, lighted cigarette butts, etc. On fine dust, for instance from plaster, concrete, flour, hot or cold ashes. Do not leave the vacuum cleaner in direct sunlight. Avoid exposing the vacuum cleaner or battery to strong heat. The battery must not be dismantled, shortcircuited, placed against a metal surface or exposed to strong heat. Without filter. Using the vacuum cleaner in the above circumstances may cause serious damage to the product. Such damage is not covered by the warranty. Servicing or repairs In cases of breakdown or faults, your UniRapido must be taken to an authorized Electrolux service centre. If the supply cord is damaged, it must be replaced by Electrolux or its service agent or a similarly qualified person in order to avoid a hazard. Consumer information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. This product is designed with the environment in mind. • Connection should be firmly made after all conductor stands are entered into the terminal posts. • When preparing the cable ends take care not to damage the outer seal, or insulation surrounding the inner conductors. • Replace the top cover of the plug and secure. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury: • • • • • • • • • • • • • • • • • • Do not use outdoors or on wet surfaces. Do not leave vacuum cleaner when plugged in. Close attention is necessary when used near children. Do not allow children to operate this appliance and accessories. Use only manufacturer's recommended attachments. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. Do not pull or carry by cord, do not use cord as a handle, and do not close door on cord. Do not use extension cords or outlets with inadequate current carrying capacity. Turn off all controls before unplugging. [. . . ] There are certain conditions which may invalidate this guarantee: a. It is dependent upon the appliance being correctly installed and used in accordance with the Company's instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland. Service at all times must be carried out by an Electrolux Service Representative or authorised agent. The guarantee may be invalidated by unauthorised repair or modification of the appliance. [. . . ]